#IC R6 VS IC R2 SERIES#
#IC R6 VS IC R2 TV#

R2 acts as a series resistance for the clamp action of the amplifier output. Wow the engineering world with your unique design: Design Ideas Submission Guide The use of four identical-value resistors makes achieving accuracy easy because of the ready availability of precision ratio-matched resistor networks. Lastly, D5 in the output of the amplifier only allows the amplifier to sink voltage from the OUTPUT node if the level attempts to exceed 2.5 V. The sensed voltage is also halved via the divider formed by R5/R6 and applied to the inverting input. To achieve this, the reference voltage is halved via the divider R3/R4 and applied to the non-inverting input. This solution (see Figure 1) is based on a rail-to-rail op amp capable of operating at 2.5 V but, even then, operating the input and output nodes of the amplifier near the center of its 0 to 2.5 V range provides the best linearity.ДЇigure 1 Clamp circuit to precision clamp a 2.5 Volt output while operating on a 2.5 Volt power supply. In addition, the signal requires a clamping voltage that is more precisely regulated than either device can provide.

Since the signalвЂ™s dynamic range is from 0 to 2.5 V, clamping it with a simple diode or Zener would eat up up too much of the signalвЂ™s range.

Auto power OFF (0.This circuit was born from an application that required an input signal to be precisely clamped to less than 2.5 V, while operating on a 2.5 V supply (actually a reference) with a maximum output of 4 mA.

Receiver-to-receiver cloning (optional OPC-474 required).

Optional CT-17, CI-V level converter for remote control.

Priority watch function with priority beep function.

150 mW loud audio with internal speaker.Earphone cord antenna for AM aviation as well asFM broadcast.в‘.0 ppm high frequency stability (at 25ЛљC).When used the optional drop-in charger stand BC-194 with the AC adapter or cigarette lighter cable, you can easily start charging the Ni-MH cells, while eliminating the need to connect the power source to the DC power jack of the receiver. Run the IC-R6 using the AC adapter, or opt for a cigarette lighter cable, CP-18A/E. The IC-R6 can be powered by rechargeable Ni-MH cells, or with alkaline batteries. It is a handy feature for those listeners who are scanning for talk, news and music, but not data bursts or beacons.* Compatibility not guaranteed. The VSC opens the squelch only when a modulated signal is detected and ignores unmodulated beat noise. Use the bank link scan feature to choose from and connect any of the 22 memory banks. With 1300 alphanumeric memory channels, 50 scan edges and 200 auto write memories, the IC-R6 gives you flexible scanning. 1300 memory channels with 22 memory banks * At 50 mW output using external speaker. With the supplied rechargeable Ni-MH cells (1400 mAh Г—2), the IC-R6 provides up to 15 hours of continuous receive capability*.

The IC-R6 is energy-efficient, designed to provide many hours of listening enjoyment on a single charge. 15 hours of continuous receive capability* This superior scanning power allows the utmost efficiency when searching over 1300MHz of spectrum! The IC-R6 has 100 channels per second high speed scan capability*. Ana 100 channels per second high speed scan

#IC R6 VS IC R2 TV#

Amateur stations, AM, FM, short wave broadcasts, TV audio* and a variety of utility communications can be caught and listened to. While the IC-R6 receives an ultra wideband frequency range, the radio provides superior sensitivity and receiver characteristics that is insusceptible to interference.

Ic-r6 vs ic-r2